Weed eaters are great tools for keeping your lawn trimmed and looking neat. However, the string on your weed eater will eventually wear out. Eventually, you’ll need to replace it. Fortunately, restringing your weed eater is a relatively simple process. In this article, we’ll discuss the basics of how to string a weed eater.
Things You’ll Need To String Your Weed Eater
Before you can begin replacing the string on your weed eater, you’ll need to make sure you have the right tools for the job. You’ll need a new spool of weed eater string, an adjustable wrench, and a pair of needle-nose pliers. Additionally, you may need a flat head screwdriver and a pair of safety glasses.
Preparing To String Your Weed Eater
Before you begin to replace the string on your weed eater, you should make sure the engine is off and the spark plug is disconnected. Additionally, you should lay down a towel or piece of cardboard to catch any parts that may fall off. This will help prevent you from losing any of the small parts.
Removing The Spool From The Weed Eater
Once you’ve gathered your tools and prepared the area, you’ll need to remove the spool from the weed eater. To do this, you’ll need to locate the spool housing. This is usually located on the side of the weed eater and is held in place by a few screws. Once you’ve located the screws, use your adjustable wrench to loosen them and remove the spool housing.
Installing The New Spool
Now that the old spool has been removed, you can begin to install the new one. Start by removing the new spool from the packaging and making sure it is compatible with your weed eater. Once you’ve done that, insert the new spool into the spool housing. Make sure it is properly seated, then use your needle-nose pliers to secure it in place.
Stringing The Weed Eater
Once the new spool is installed, it’s time to start stringing the weed eater. To do this, you’ll need to wind the string around the spool. Start by wrapping the string around the spool several times, then cut the string with a pair of scissors. Now, you’ll need to attach the string to the spool. This is usually done by inserting the string through a hole in the spool and then wrapping it around the stem of the spool several times.
Reinstalling The Spool Housing
Once you’ve finished stringing the weed eater, you’ll need to reinstall the spool housing. To do this, simply slide the spool housing back into place and use your adjustable wrench to tighten the screws. When you’ve finished, make sure the spool is properly seated and the string is not tangled.
Testing The Weed Eater
Now that the weed eater is restrung, you should test it out to make sure it is working properly. Start by reconnecting the spark plug and turning on the engine. If the string is properly installed, it should start spinning as soon as the engine is engaged. If it does not spin, make sure the string is not tangled and that the spool is properly seated.
Conclusion
Restringing a weed eater is a relatively simple process. With the right tools and a bit of patience, you can easily replace the string on your weed eater. Just make sure to always wear safety glasses and keep your hands and fingers away from the spinning string. With a little bit of practice, you’ll be able to quickly and easily restring your weed eater.
